Honeywell - Commercial Flame Amplifiers
Flame Amplifier is a solid state plug-in amplifier that responds to a rectified,
optical, ultraviolet or infrared signal.
R7824
Solid state plug-in amplifiers that respond to flame detector inputs to
indicate the presence of flame when used with 7800 SERIES relay modules.
|
R7847
Solid state plug-in amplifiers that respond to flame detector inputs to
indicate the presence of flame when used with 7800 SERIES relay modules.
|
R7848
Solid state plug-in amplifiers that respond to flame detector inputs to
indicate the presence of flame when used with 7800 SERIES relay modules.
|
R7849
Solid state plug-in amplifiers that respond to flame detector inputs to indicate
the presence of flame when used with 7800 SERIES relay modules
|
R7851
Solid state plug-in amplifiers that respond to flame detector inputs to
indicate the presence of flame when used with 7800 SERIES relay modules.
|
R7861
Solid state plug-in amplifiers that respond to flame detector inputs to
indicate the presence of flame when used with 7800 SERIES relay modules.
|
R7886
Solid state plug-in amplifiers that respond to flame detector inputs to
indicate the presence of flame when used with 7800 SERIES relay modules.
|
R7852
Solid state plug-in non-self checking infrared amplifier which amplifies a small electrical signal generated by a flame to produce the flame on or flame off signal. Designed to work with the C7915A IR flame detector.
|
R7061
Solid State dynamic self check amplifier. Used with UV dynamic self check sensor C7061.
|
R7247
Solid state plug-in units respond to flame detector signal and indicate
presence of flame.
|
R7248
Solid state plug-in units respond to flame detector signal and indicate
presence of flame.
|
R7249
Solid state plug-in units respond to flame detector signal and indicate
presence of flame.
|
R7289
Solid state, plug-in units allow use of rectification or ultraviolet flame
detection. Use with R4795A,D Flame Safeguard primary controls and appropriate
flame detector.
|
R7290
Solid state, plug-in units allow use of rectification or ultraviolet flame
detection. Use with R4795A,D Flame Safeguard primary controls and appropriate
flame detector.
|
R7476
Solid state plug-in units respond to flame detector signal and indicate
presence of flame.
|
